Bercomac 700524-1 Feuille D'instructions

BATTERY SUPPORT WITH WIRING #700524-1
For the Versatile Plus and Prestige snowblower, the battery support hides the security decal
105130. Place a new decal 105130 (provided within the kit) in a visible place. Clean and dry the
surface of the snowblower before sticking the decal.
For the Versatile Plus and Prestige snowblowers:
Place the battery support (item 1) on the left side of
the snowblower as shown. Leave a clearance of 5.5''
to permit movement of the tensioner.
Drill two holes (item 2) through the snowblower frame
with a 11/32'' bit.
Secure the battery support with two 5/16'' x 3/4'' hex.
bolts (item 3) et two nylon insert lock nuts 5/16'' (item
4).
For the vantage snowblower:
Place the battery support over the holes that are
drilled at the back of the snowblower (not illustrated)
on the right hand side.
Secure the battery support with two 5/16'' x 3/4" hex
bolts (item 3) and with the nylon insert lock nuts (item
4) supplied in the kit. Tighten the nuts firmly.
For the Versatile snowblowers:
Place the battery support (item 5) on the right side of
the snowblower as shown.
Drill two holes (item 6) through the snowblower frame
with a 11/32 bit.
Secure the battery support with two 5/16'' x 3/4'' hex.
bolts (item 7) et two nylon insert lock nuts 5/16'' (item
8).
FI_700524-1_EN
INSTALLATION
Caution
Install the kit according to the following instructions:
Instruction Sheet
Install the battery support on the Versatile plus
6
7
5
Install the battery support on the Versatile
8
M-11