Swagman SEMI 4.0 Add-On Mode D'assemblage

INSTRUCTION SHEET
PRODUCT: 64699 SEMI 4.0 Add-On • Page 1 of 2
This rack is designed to be mounted on the SEMI 4.0 2 Bike rack. It
can also be used as a Add-On section for the Swagman Quad 2 Plus 2.
Removing the Add-On section on the Quad 2 Plus 2 and replace with
this model.
Assembly Instructions:
1. Remove main Add-On assembly (A) from box.
2. Install the front and rear wheel holders on the horizontal arms using
the tapered Allen bolts. The front wheel holder has 2 bolts (diagram 1)
and the rear has 3 bolts (diagram 2) so you cannot mount on the
wrong location on the horizontal arm. NOTE: Do not over-tighten
the Allen bolts.
3. Push the male horizontal section (with ratchet upright attached)
into the female horizontal section (diagram 3).
4. Attach the Add-On Section to the main SEMI 4.0 2 Bike rack using
the 10mm Allen bolt using the supplied 10mm Allen Wrench.
5. Insert the 6mm set screw and tighten.
6. Starting with the crossbar assembly closest to the vehicle, position
it so the ratchet upright is on the opposite side to the upright on
the 2 bike rack. Place the remaining cross bar onto main assembly
(A) (diagram 4). Note the orientation of the crossbars on the add-on
assembly. It is important that they are in this orientation so that
each bike can be installed facing opposite direction.
7. Insert 2 carriage bolts into the holes and secure with the washer
and nut. Repeat procedure on second cross bar assembly. Tighten
nuts securely.
Loading Bikes
1. Move the ratchet arm forward. Push the ratchet release and move
the ratchet hook assembly to the end of the ratchet arm (NOTE 1 –
diagram 5).
2. Put the bike into the wheel trays with the front wheel in the
upswept wheel tray.
3. While holding the bike rotate the ratchet arm upward towards the
fork crown.
4. Position the hook assembly tight against the fork crown or front
brake of the bike (diagram 6).
5. Pull the hook downward so that the hook is tight against the tire.
After the hook contacts the tire push down hard until you hear an
extra click in the ratchet release. NOTE: The hooks should be tight
against the fork crown and the tire. Move the bike back and forth to
ensure it is fully seating. Readjust as necessary.
6. Move the strap in the rear wheel tray so it is positioned in the center
of the tire (diagram 7).
7. Push the strap through the buckle and pull the strap tight. NOTE:
On smaller wheels you will need to use the spacer block on the strap.
8. If carrying one bike use the inside position, nearest to the vehicle.
IMPORTANT: You have to ensure that all of the wheel straps are
attached and secure.
9. Pull lock out of the holder at the end of each arm. Loop the cable
through the bike frame and then attach it to the lock post on the
ratchet arm (diagram 8).
300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
#1
#1
A
#2
1
2
3
4
#2
REV 23/10/19