Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PRODUCT
(Fig. A)
1.
ON/OFF Switch
2.
LED ON Indicator
3.
Filling/Safety Cap
4.
Manometer
5.
Steam Generator
6.
Hose
7.
Trigger Lock
8.
Trigger
9.
Steam Gun
10. Extension Handle
11. Tube Supporter
12. Pin Nozzle
13. 3-Pin Nozzle
14. Measuring Jug
15. Funnel
16. Weed Cone
17. Window Cleaner
18. Floor Brush Adapter
19. Straight Adapter
20. Floor Brush
21. Jet Nozzle
22. Large Brush
23. Small Brush
24. Cleaning Cloth
OPERATION
Filling the water tank:
Never fill the tank while the machine
is plugged in
1.
Unscrew the Filling/Safety cap (3) (Fig. B)
2.
Fill the tank using the funnel and measur-
ing cup provided. The tank holds up to
1800 ml. of water DO NOT overfill the
water tank (Fig. C)
3.
Fasten the filling/safety cap tightly into
place (Fig. D)
Refilling the water tank:
If the unit has been in use, ALWAYS follow
these safety precautions before removing the
water tank filling/safety cap:
–
Switch the unit to the OFF position and
7062741_SteamBoxxer_Ma-#1612-05.indb 13
unplug the unit. Allow at least 30 minutes
for the unit to cool.
–
Release all the steam pressure in the unit
by pressing the steam nozzle flow trigger
Warning: Failure to follow these precautions
may result in burns from escaping steam when
the water tank safety cap is removed
Note: Safety/filling cap will rotate but will not
unscrew until unit is cool and pressure is
released
Steam gun operation:
(Fig. E)
–
The steam output is controlled through the
steam gun. The steam gun has steam
trigger and a safety switch.
–
The safety switch is marked with "OFF/
LOCK, ON".
–
Set the safety button to the "ON" position,
pull the steam trigger to release the steam.
–
After use release the steam trigger and
lock the safety button in the "OFF/LOCK"
position. So that the steam trigger cannot
be pressed accidentally.
USE:
1.
Make sure the machine is unplugged from
the mains
2.
Fill the water tank (see Filling the water
tank)
3.
Attach the accessory or tool you require to
the machine
4.
Plug the machine into the mains and
switch on. Two lights should illuminate.
The red light (1) is a power indicator. The
orange light (2) indicates that the machine
is building up steam pressure. When the
machine is first turned on this light will
illuminate and the machine can take up to
15 minutes to reach the correct pressure
level, depending on the amount of water in
the tank. On the manometer (4), the pres-
sure should be around 4.2 bar.
5.
Once the orange light has gone out the
machine is ready to use. The orange light
may come back on when the machine is in
use.
6.
On the manometer, the pressure should
be around 2.5 bar.
.
English
13
06-12-16 14:16
Publicité
Table des Matières
