Wiring Diagram - Venture Lighting SELECT-PRO MODERN HIGHBAY Manuel Utilisateur

Installation Instructions – 1/2" Pendant Mount
Remove hole plugs from 4 screw holes on fixture heatsink. Use bracket as a guide to determine which plugs to remove.
6:
Attach fixture to Surface Bracket by utilizing the provided mounting hardware.
7:
Set fixture to proper angle and tighten angle adjustment screws. (Figure 6)
8:
Screw on lock nut to ½" threaded pipe.
9:
Threaded pipe will pass through the center hole on the Surface Bracket.
10:
Add second lock nut to pipe to secure fixture and bracket to pipe. (Figure 7)
11:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
12:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed). DO
NOT connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
Power can now be restored to the system.
13:
Installation Instructions – 3/4" Pendant Mount
Remove eye bolt from fixture.
6:
Screw in ¾" pendant mount accessory. (Figure 8)
7:
Route power and dimming wires through pendant accessory and ¾" pipe.
8:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
9:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires
separately (bare wires should not be left exposed). DO NOT connect the Driver Dim(+) (purple) to the
Driver Dim(-) (pink) wire as the fixture will not operate correctly.
Power can now be restored to the system.
10:

Wiring Diagram:

(800) 451-2606
6675 Parkland Blvd., Suite 100
Solon, Ohio 44139 USA
E-mail: Venture_Lighting@VentureLighting.com
VentureLighting.com
©2022 Venture Lighting International Venture Lighting is a registered trademark of Venture Lighting International.

Figure 7
Figure 8
AK0061-B