Installation Instructions - Venture Lighting SELECT-PRO MODERN HIGHBAY Manuel Utilisateur

Installation Instructions

Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
1:
Remove the existing luminaire (if present) and dispose of per local requirements.
2:
Default CCT – 5000K; Default Wattage - Highest.
3:
Use selector switch to choose CCT and Wattage setting. (Figure 1)
4:
Attach safety cable to screw hole on fixture. Once fixture installation is complete, connect other end of cable to
5:
.
ceiling or mounting surface
Installation Instructions – Suspension Mount
Attach chain or cable to eye-bolt on top of fixture. (Figure 2)
6:
Attach chain or cable to ceiling structure.
7:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
8:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed). DO
NOT connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
Power can now be restored to the system.
9:
Installation Instructions – Surface Mount
Remove hole plugs from 4 screw holes on fixture heatsink. Use bracket as a guide to determine which plugs to remove.
6:
Attach fixture to Surface Bracket by utilizing the provided mounting hardware.
7:
Surface kit is supplied with anchors. Drill (2) 10mm holes in ceiling. Use bracket as template.
8:
Use hammer to pound supplied anchors into holes. (Figure 3)
9:
Attach surface bracket to anchors and tighten nuts. (Figure 4 & 5)
10:
Set fixture to proper angle and tighten angle adjustment screws. (Figure 6)
11:
Connect the supply wires to junction box, or similar, as shown in wiring diagram below.
12:
NOTE: The correct polarity of the dimming connections is essential to proper operation.
NOTE: If not using the dimming functionality, insulate the Dim(+) (purple) and Dim(-) (pink) wires separately (bare wires should not be left exposed). DO
NOT connect the Driver Dim(+) (purple) to the Driver Dim(-) (pink) wire as the fixture will not operate correctly.
Power can now be restored to the system.
13:
Figure 3
(800) 451-2606 VentureLighting.com
Figure 4 Figure 5
Figure 1
Figure 2
Figure 6