Replacing Blades; Routine Servicing - Jacques Seban Haircut Guide De L'utilisateur

EN
 Install the blades by first inserting the rear part (Fig. 5c). Press the blades with
your thumb to clip them in.
 Switch the clippers on for a few seconds after lubricating them.

3.7 Replacing blades

The clippers are delivered with 2 sets of blades, 25 mm and 32 mm wide.
Other blades are proposed as an option, contact your dealer.
 To remove and install the blades, refer to Fig. 5a and 5c.
4 Servicing

4.1 Routine servicing

 After using the clippers each time, clean the blades with the brush supplied
(fig. 1-J).
 If necessary, clean the body of the clippers with a cloth slightly dampened with
water or mild liquid soap. Never use abrasive products or solvents.
 Clean the blades with an antibacterial spray. We recommend STERIL CLEANER
920- or 921- disinfectant and lubricant products.
 Lubricate the blades at least once a day (see § 3.6).
4.2 Cleaning the blades
In the case of regular use, clean the blades at least once a day.
 Remove the blades as described in § 3.6.
 Clean the inside of the blades with the brush supplied.
 With your thumb, press on the 2 lugs (arrows) to move the fixed/mobile blades
(Fig. 6). Eliminate all cutting debris and residues stuck between the blades.
 Lubricate the blades and put back on the clippers as described in § 3.6.
26