Jacques Seban Haircut Guide De L'utilisateur page 25

 When the clippers are not in use, it is recommended to clip the cutter cover
(Fig. 1-K) onto the blades.
Use with or without power lead
 With a new, fully charged battery, the clippers can be used without the power
lead for about 100 minutes. The LCD shows the remaining autonomy (Fig. 1-R).
 Before the end of the autonomy period, the charge light flashes (Fig. 1-S).
Recharge the clippers, refer to § 3.1.
 The clippers can be used with power lead. For this, connect the cable to the
clippers (Fig. 3a) and connect the power pack (Fig. 1-H) to a mains power
socket.
3.3 Adjusting the cutting height
 Press the centre button (Fig. 4a) and push the sliding knob. Select a cutting
height: 0.4 – 0.6 - 0.8 mm.
 Release the centre button.
3.4 Using the comb attachments
 The clippers must be switched off. Select a comb attachment: 3, 6, 9 or 12 mm
(Fig. 1 refs. M-P).
 Place the comb attachment on the blades (Fig. 4b) and clip in at rear. When
the comb attachment is correctly fixed, it is immobilized.
 To remove the comb attachment, unclip by the rear tab (Fig. 4b).
3.5 Using the Turbo function
 Activating the Turbo function: press the button (Fig. 1-C). The indicator comes
on. The cutting speed and power are increased by about 20%.
 Disabling the Turbo function: press the button again (Fig. 1-C).
3.6 Lubricating the cutters
After 30 minutes of use, it is recommended to lubricate the cutters.
 Stop the clippers and place the sliding knob in 0.8 mm position (Fig. 4a).
 Removing blades: hold the blades with your thumb and press on the spot shown
by the arrow (Fig. 5a).
 Apply 1 drop of lubricating oil to the 5 points shown (Fig. 5b).
Use only the oil supplied.
25
EN