Using The Appliance; Cleaning And Maintenance - NORAUTO COMPACT 2441575 Manuel D'utilisation Et De Sécurité

ASSEMBLY
EN
IMPORTANT:
• Filter must be always clean before use.
• Fit the filter in the dust container. Pay attention to the markings both on the components
of the appliance and the dust container.
• Fit the dust container onto the body of the vacuum cleaner. Ensure the dust container is
securely installed.
ACCESSORIES, FITTING AND REMOVING ACCESSORIES
• CAUTION: Before changing accessories, always switch the vacuum cleaner off first!
• CAUTION: Risk of injury! Never hold the crevice nozzle close to the body or it may stick to
the skin. If the nozzle does get stuck, switch off the appliance immediately.
• NOTE: You can use the vacuum cleaner either without an accessory or fit the accessories
to the suction opening as shown below.
• When fitting the accessory, insert it into the suction opening.
• To remove the accessory, pull it out of the suction opening.
• The crevice nozzle is designed for upholstery, cleaning the interior of cars, boats, and
getting into all corners and cracks that are inaccessible.
• The round brush is especially effective at picking up dust and particles from mats, seats.

USING THE APPLIANCE

1. Place the vacuum cleaner on a flat, steady, heat-resistant surface.
2. Ensure that the 0/I switch is in the 0 (OFF) position.
3. Insert the desired accessory into the unit.
4. Fully unwind the 12 V car connector supply cord.
5. IMPORTANT: Prior to plugging in the cigarette lighter plug into the cigarette lighter
socket, turn on the ignition. It prevents a power surge that can lead to the unit
overheating and/or becoming a potential fire risk.
6. Insert the cigarette lighter plug to the cigarette lighter socket in a vehicle or boat.
7. Slide the 0/I switch forward to the I (ON) position to turn the vacuum cleaner on.
8. To switch off the unit, slide the 0/I switch back to the 0 (OFF) position and disconnect the
12 V connector supply cord.

CLEANING AND MAINTENANCE

• WARNING: Always ensure that the 0/I switch is in the 0 (OFF) position and disconnect the
vacuum cleaner from the power supply before cleaning or maintenance.
• Never immerse the unit and its accessories in water or other liquids. Immersion of any of
the accessories may cause damage or malfunction.
• Wipe the exterior of the vacuum cleaner with a soft, dry cloth.
• Do not use abrasive cleaning agents or hard objects during cleaning as these can damage
the product and its accessories.
• Keep the air outlets free of any dust and dirt, so that heat can be released and the
vacuum cleaner is not damaged.
24