User Manual - SBS Jaz audio TWS Mode D'emploi

UK
INSTRUCTION MANUAL
Recharging the base
Using a USB charging cable insert one end into the micro USB port
and then connect the other to the USB port of a computer or a travel
battery charger.
The base's LED charging light flashes red during the charging phase
and turns solid red once charging is complete.
When fully charged, by pressing the power button on the base once
the LED lights up in blue.
Charging the earphones
Plug the headphones into the bottom then press the power button
at the base. The LED on the headphones will turn red, then become
blue once they are fully charged, before turning off altogether after
a few minutes.
Initial pairing (only required when pairing for the first time)
Press both MLF buttons on the earphones until the LEDs flash red
and blue.
Now, keep the MLF button on the right earphone pressed for about
3-4 seconds.
Wait a few seconds for both eaphones to connect to each other. Once
a connection is established, the LED on the right earphone will flash
red and blue, while the one on the left earphone will stop flashing.
Open your smartphone's Bluetooth settings and select "JAZ
SYMPHONY".
Switching on and associating both earphones
- Press and hold down the multi-function buttons (MLF) of the
earphones at the same time, until both the LEDs flash alternately
Blue / Red, and then let go.
- Wait a few seconds for the two earphones to associate with each
other. When the connection is made between them, only the LED on
the left earpiece will continue to flash alternately Red / Blue. Now
activate the Bluetooth on your phone --> and the pair of earphones
will be listed as the only device, searching for and selecting MINI
TWS LIGHT.
- Once the pair of earphones is connected to the smartphone, the LED
of both flashes Blue only --> meaning that the pair of earphones
and smartphone have been successfully associated!
Connection of a single ear piece (Left or Right)
- Press and hold down the multi-function button (MLF) on the
headset for a few seconds, until the LED starts blinking Blue / Red
alternately, then let go.
- Activate the phone's Bluetooth --> search and select MINI TWS
LIGHT.
4