Battery Running Low; Connecting With An Audio Cable - Marmitek BOOMBOOM 565 Guide Utilisateur

BATTERY RUNNING LOW

When the battery of the BoomBoom 565 is running low, you will hear
an audio warning. After 3 to 5 minutes the BoomBoom 565 will
automatically switch off. When the Active Noise Control battery is
empty, the Active Noise Control LED remains off after activation.
Follow the steps as described earlier to recharge the battery.
CONNECTING WITH AN AUDIO
CABLE
The Bluetooth connection can be switched to a wired connection by
plugging the cable into the 3.5mm audio jack. This may be useful
when the battery has run out and you still want to use headphones.
Press and hold the Multi-function button for 5 seconds to turn OFF
the BoomBoom 565 if it is still on. Now, use the supplied audio cable
to connect the BoomBoom 565 to the headphones connector of your
audio source. It is not possible to use the function keys in the wired
connection mode. However, Active Noise Control can be activated
using the switch [18]. Simply detach the 3.5mm audio connector and
press the power button for 5 seconds to return to the Bluetooth
connection.
10 © MARMITEK