SIGNIFY Day-Brite CFI Fluxstream EZ LED Instructions D'installation page 2

INSTALLATION INSTRUCTIONS
FLUXSTREAM EZ LED
Page 2 of 4
FOR FIXTURE MAINTENANCE (ACCESSING WIRING COMPARTMENT)
To remove lens from housing, push side of lens until the opposite side of lens protrudes from housing. Then pull protruding lens downward until
removed as shown in Figure 5. This should be applied down the length of the fixture. To remove the LED board, start on one end of housing
using a flat head screw driver in the slots provided as shown in Figure 6. IMPORTANT: Make sure to apply a force parallel to board to reduce
the risk of damaging the board.
FIGURE 5: REMOVING LENS
CONNECTING LUMINAIRES FOR ROW MOUNTING
1) Make sure each luminaire is secured to building structure, by at least two points, before process begins, do not use "endcap to endcap"
connection for replacing cable, pendant or surface mounting options.
2) Remove joining end caps by spreading channel open and sliding endcap off. Then remove KOs and secure the endcaps together with
customer supplied (2) #8 screws and (1) 1/2" chase nipple to create joiner as shown in FIG 6.
3) Slide joiner assembly/endcap into fixture. Slide in next luminaire into joiner assembly as shown in FIG 7.
FIG 7: JOINER ASSY
4) Install screws as shown in FIG 8 and make electrical conncetions inside luminaire in accordance with the National Code and local
regulations. Refer to page 2 for installing the LED carrier and lens.
CAUTION:
This fixture is designed for permanent installation in ordinary (Non-Hazardous) locations in accordance with the National Electrical Code and
all applicable local codes. Do not use in areas of limited ventilation or in high ambient enclosures. The lamp and fixture operate at high temperatures.
Contact with combustible materials can cause fire and personal contact can cause severe burns.
CAUTION: THE INSTALLATION AND SERVICING OF
THIS PRODUCT SHOULD BE PERFORMED BY A
QUALIFIED ELECTRICIAN OR SERVICE PERSONNEL
FIG 9: ROW MOUNT CONFIGURATION
FIGURE 6: REMOVING THE 4' LED BOARD
FIG 8: ROW MOUNT CONNECTION
12NC: 44210025