WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their riding lawn mower before
using this accessory. Save these instructions. Refer to them
frequently and use them to instruct other users. If you loan
someone this product, loan them these instructions also.
PACKING LIST
Bagging Blades (2)
Hitch Pin
Bags (2)
Lower Bagger Tube
INSTALLING THE BAGGING KIT
The ACRM008 Bagging Kit is compatible with Ryobi
that have a 30 inch deck. This kit includes a bagger and special
mower blades designed to be used when bagging. Install the
blades first, then install the bagging kit.
REMOVING THE CUTTING DECK
See Figure 1.
If desired, the cutting deck can be removed from the mower to
make accessing the blades easier when changing.
Stop the motor, remove the start key, and set the parking
brake.
Disconnect the cables that connect the cutting deck to the
mower.
Lower the cutting deck to its lowest position.
Remove the 4 hitch pins and washers that secure the cutting
deck in place.
Slide the deck out from under the mower.
Reverse the process to reattach the cutting deck to the
mower.
INSTALLING BAGGING BLADES
See Figures 2 - 4.
CAUTION:
Only use replacement blade bolts authorized by the
manufacturer of your riding mower. Use of blade bolts not
authorized is hazardous and may damage your riding mower.
Make sure direction control switch is in neutral (N) position
and blade engage knob is down.
Stop the motor, remove the start key, and set the parking
brake.
Raise the height of the cutting deck to its highest position
to allow access to blades.
NOTE: If necessary, raise the mower by placing on a lift or
using a jack and jack stands, or remove the cutting deck
as described in the previous section to gain access to the
blades.
ACRM008 BAGGING KIT
FOR USE WITH RYOBI
Bagger Bracket
Bagger Cover
Upper Bagger Tube
mowers
®
30 in. ELECTRIC RIDING LAWN MOWER
®
CUTTING
DECK
WASHER
WRENCH
BLOCK OF WOOD
WARNING:
If raising the mower to access the blades, make sure the
mower is properly secured and the parking brake is set
before proceeding. Failure to properly secure the mower
could cause it to fall, resulting in possible death or serious
personal injury.
CABLE
HITCH PIN
Fig. 1
BLADE
Fig. 2