System Configuration - Idegis Domotic Serie Manuel D'installation Et D'entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
5.
OPERATION: __________________________________________________________________________________________________
5.1.
System on stand-by
The system goes into "STAND-BY" when the "" [1] key is pressed until the "0%" light blinks. When this occurs, there is no production in the
electrolysis cell.
5.2.

System configuration

The DOMOTIC Series system can be reconfigured through a menu accessed from the control panel. The system has to be switched off, as
described in point 5.1, in order to access this menu. Once the system has been switched off, press the "" [1] key for a few seconds until the
system information screen [11] displays "CONF". To enable selection of each menu option, keep the "SALT TEST" [9] key pressed for
approximately 1 second. Select the desired parameter using the "" [1] / "" [14] keys and validate by pressing the "SALT TEST" [9] key for
one second again (see Fig. 23). The configuration process enables you to establish the following operative parameters:
MODEL
SOFTWARE VERSION
POLARITY SWITCH
OUTPUT LEVEL CONTROL
WHEN CLOSED COVER
COVER CONTROL INPUT ACTIVATION
ORP/RESIDUAL CHLORINE
CONTROL INPUT ACTIVATION
GAS DETECTOR ACTIVATION
EXTERNAL FLOW DETECTOR
(FLOW SWITCH) ACTIVATION
(1)
WARNING: only use this mode for check tasks, for short periods of time, as it could damage the electrodes. This mode is cancelled when the system is switched off.
(2)
Factory defaults.
(3)
Factory default value in DOM-XX PLUS systems.
Fig. 21
domotic
domotic
12
Shows software version (two digits)
(2)
Switch every 2 hours
(2)
System may be configured to provide an output to cell in the range 10 ... 90% of its nominal
capacity when the pool cover is closed.
Activated input when closed
Deactivated
(2)
Deactivated (MANUAL)
Activated electrolysis system when closed contact (AUTO)
Deactivated
(2)
Deactivated
Fig. 22
14
domotic
32
24
Switch every 3 hours
Switch every 2 minutes
Activated input when open
(2)
contact
Activated electrolysis system when flooded detector
Activated electrolysis system when closed contact
domotic
42
(1)
contact
(3)
(2)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Domotic dom-12Domotic dom-12 phDomotic dom-12 plusDomotic dom-24Domotic dom-24 phDomotic dom-24 plus ... Afficher tout

Table des Matières