Team kalorik PSGR 2000 RI Mode D'emploi page 6

MAINTENANCE
Clean the housing and grinding head with a damp cloth and dry with a paper towel. Do
not immerse the mill in liquid or put it in a dishwasher. Do not use with wet hands. Do not
use cleaning products or detergents.
BATTERIES
If your appliance does not work properly, it is probably because the batteries are
discharged. In that case, replace them with new ones of the same type (see "Before
use"). Please eliminate the old batteries in an environmentally friendly way.
Important:
Do not mix old and new batteries
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.)
batteries
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please check that the
batteries are installed correctly and are not discharged. For best results we recommend
alkaline batteries.
If the mill gets stuck during use (motor produces hum, but internal shaft does not turn and
no pepper is ground], gently shake the mill or tap the mill gently on a hard surface, to
remove the stuck pepper or salt.
To remove deeply stuck peppercorn, remove the upper lid as if for re-filling the mill, turn
the coarseness setting to its coarsest, and tap lightly on a hard surface until all the
peppercorn is released. Re-adjust coarseness setting to the desired level once done and
replace upper lid.
Note: Too fine a grind setting may not enable salt or pepper to be ground. If this is the
case, set the grinder to a coarser setting (see above).
PSGR 2000 RI 6