y) Troubleshooting
Problems
Burner won't light
Burner
"pops"
or
blows
itself out
Excessive flare-up
Burner lights with a match,
but not with the electronic
igniter
Probable
causes
/
remedies
- Lack of gas supply
- Regulator does not work
- Hose, valve, jet, venturi
tube or burner openings are
blocked.
- Venturi tube not seated over
jet
- The STOPGAZ system's
thermocouple is not hot
enough; repeat the ignition
sequence,
keeping
the
control button depressed for
15 to 20 seconds. If the
burner still does not light,
contact
the
after
sales
department.
- Check gas supply
- Check hose connections
- Contact the After Sales
Service
- Clean the protective plate
above the burner.
- Clean the grease drip tray
- Grill temperature too high:
lower flame
- Faulty
igniter,
wire
electrode
- Check
igniter
cable
connections
- Check condition of electrode
and connection wire
- Contact the After Sales
Service
Problems
Fire at any connection
Incomplete flame around
burner
Lack of Heat
Fire behind control knob
Fire under control panel
or
13
Probable
causes
/
remedies
- Leaking connection
- Turn off gas supply at
cylinder immediately
- Tighten connections and
check for leaks
- Contact After Sales Service
- Defective
or
clogged
burner: relocate the Venturi.
- Clogged jets: clean the
Venturi
- Contact After Sales Service
- Clogged jet or venturi tube
- Contact
After
Sales
Service
- Defective tap unit
- Turn off gas supply at
cylinder immediately
- Contact After Sales Service
- Turn off gas supply at
cylinder immediately
- Contact After Sales Service
GB