Hkoenig swip150 Manuel D'instructions page 9

• Place the front of your shoe onto the cleaning pad removal Tab and press down firmly.
Attaching Carpet Gilder
l
Press the micro-fiber cleaning pad L with main body to
Carpet gilder F by vertical pressure，until it into place.
l
Place the front of your shoe onto the cleaning pad removal tab
And press down firmly, carpet gilder will remove form steam head.
OPERATION
1.Filling the water tank
Method one：
Open the water tank cup 5, fill 370 ml water use measuring cup,
And then to close water tank cup 5
Method two：
l
Remove the water tank from main body，open
the Water tank cup 5, fill The water tank from
water faucet and then to close water tank
cup 5;
l
Install the water tank5 to main body C until it clicks into place.
2.Plug in the appliance to a grounded outlet.
3. When switch the appliance on, the indicator lights will turn red, it indicate preheating. If the lights
does not illuminate, please check the "troubleshooting" section for more details；
4. The product cold warm-up time of 30 seconds, after the completion of the preheat indicator color
conversion is blue, the product began to work;
NOTICE: If power failure in the middle of the warm-up or power-off after the warm-up is
complete, turn the power supply on again, according to the interval of the power is turned on
again, the product may repeat the above warm-up operation.
5. When normal cleaning, the steam head has big rotary angle, can clean corners and also can
clean low space.
6.Add control volume by turn steam control knob 8 clockwise，