Publicité
Les langues disponibles
Les langues disponibles
WIRING CONNECTIONS
Do not run wiring in the same conduit with AC power.
1. Disconnect power to the operator.
2. Wire the coil cord to the junction box. Twist both black/white wires from the photoelectric sensors together and connect them to the white wire
from the coil cord. Twist both black wires from the photoelectric sensors together and connect them to the brown wire from the coil cord. NOTE:
The black/white wire is common, and the black wire is positive.
3. Connect the coil cord wires to the logic board on the operator. The wiring is polarity sensitive so make certain to wire as indicated:
Medium Duty Logic:
Connect the white wire to the LMEP2 and the brown wire to LMEP1 on the logic board.
FDO, FDC, FDCL and Egress Operators:
Connect the white wire to J2 terminal 2 and the brown wire to J2 terminal 1 on the logic board.
Heavy, Standard Logic 4:
Connect the white wire to the common and the brown wire to LMEP on the logic board.
Heavy, Standard Logic 4 (connected through the control station):
See illustration.
MEDIUM DUTY LOGIC
Control Board
HEAVY, STANDARD LOGIC 4
Control Board
24VAC
POWER
24VAC
TIMER
DEFEAT
COMMON
MAS
LMEP:
TTC
TIMER
EDGE:
ENABLE
OPEN
3
CLOSE
REPLACEMENT PARTS
OES-EDSR: Photoelectric sensors (transmitter and receiver) with 33 feet (10.1 m) connection cable.
OES-JBOX: Junction box with wire nuts.
OES-COIL: 2-wire coil for doors up to 20 feet (6.1 m) high.
OES-RDCK: Bumpers (2).
ACCESSORIES
OES-COND: Conduit Kit with 2 junction boxes and 2 flexible cables.
OES-RD50: Rubber extrusion 50' (15.2 m) roll of photoelectric rolling door extrusion.
01-36885
White (Coil Cord)
Brown (Coil Cord)
White (Coil Cord)
Brown (Coil Cord)
1-800-528-2806
www.liftmaster.com
© 2013, The Chamberlain Group, Inc.
All Rights Reserved
FDO, FDC, FDCL AND EGRESS OPERATORS
Control Board
13 14 15 16 17 18 19 20 21 22 23 24
1 2 3 4 5 6 7 8 9 10 11 12
HEAVY, STANDARD LOGIC 4
(CONNECTED THROUGH THE CONTROL STATION)
Control Board
additional wire connection from the
operator to the control station (total
of 6 wires from the operator to the
control station is recommended).
J2
Maintenance
Maintenance
Alert LED
Alert LED
Control Board
This method requires one
This method requires one
additional wire connection
from the operator to the
control station (total of 6
wires from the operator to
the control station is
recommended).
Control
Control
Station
Station
Wire
Wire
Nut
Nut
Brown
(Coil
Brown
Cord)
Blue
White
(Coil
Cord)
Publicité
