Amcor D-850 Notice D'emploi page 7

ENGLISH
The unit can be either located on the floor or be hung on the wall.
Standing on the floor
The unit is equipped with 4 plastic legs. Make sure that all the legs are supported by
the floor.
Hanging on the wall
The unit can be hung on 2 screws inserted in the wall.
In the attached plastic bag please find two screws & two plastic wall inserts suitable
for those screws.
The two screws should be horizontally located on the wall with a distance of 450
mm. between them. On the metal rear panel of the unit there are two pear like slots
in which the heads of the screws should be inserted.
In order to eliminate vibrations and noise the two rubber supports in the attached
plastic bag should be fixed to the lower corners of the unit's rear panel.
(Peel off the cover from the self adhesive strip attached to the rubber support and
stick the supports to the rear panel).
There are four optional outlets for the drainage tube. In order to change the outlet of
the drainage tube the rear panel should be dismounted.
When remounting the rear panel care should be taken to return all the screws and
washers to their original location.
Connecting the permanent outlet
• Connect the pipe to an outlet tube with the correct diameter.
• Push the other end of the tube into a drain, making sure that the tubing cannot be
twisted or folded.
• The entire length of the tube must be slightly inclined.
• Ensure that the outlet of the drainage pipe is NOT under the water level in
the drain.
NOTE: In very cold weather conditions precautions should be taken to prevent the
drainage pipe from freezing.
7
Location
Drainage