Samsung HT-D4500 Guide D'utilisation page 24

Connections
Wireless Network
You can connect the home theater to your network through a wireless IP sharer (router).
1. Connect the wireless LAN adapter (sold separately) to the Wireless LAN Adapter jack on the rear
panel of the product.
2. Set the network options. (See page 33)
Broadband
service
Wireless IP sharer
PC
✎
NOTE

This product is compatible with Samsung's Wireless LAN Adapter only. (Model name: WIS09ABGN).
- The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer to
purchasing.

You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable
operation of the wireless network.)

Wireless LAN, by its nature, may cause interference, depending on the network environment (router
performance, distance, obstacles, interference by other radio devices, etc).

Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.

The home theater supports the following security protocols only:
1) Authentication Mode : WEP, WPAPSK, WPA2PSK
2) Encryption Type : WEP, AES

For the AllShare function, a PC must be connected in the network as shown in the fi gure.
FM Antenna (supplied)
FM ANT
HDMI OUT HDMI OUT
24
English
HT-D4500_XAC_1223.indd 24 HT-D4500_XAC_1223.indd 24
Networking with PC for
AllShare function
(See page 62)
Connecting the FM Antenna
1. Connect the FM antenna supplied to the FM
ANTENNA Jack.
2. Slowly move the antenna wire around until you fi nd
a location where reception is good, then fasten it to
a wall or other rigid surface.
✎
NOTE

LAN LAN
WIRELESS LAN
5V 350mA
Wireless LAN Adapter
(not supplied)
This product does not receive AM broadcasts.
COMPONENT OUT COMPONENT OUT
AUX IN AUX IN VIDEO OUT VIDEO OUT
2011-12-23 2011-12-23 3:46:17 3:46:17