Proslat Garage Gator 68223 Instructions D'assemblage, D'entretien Et D'utilisation page 12

Installation (continued)
5
Install straps
□ Place the straps coming out of the rectangular opening closest to the spacer channel
bar (fig. D) over the top of the pulley at the end of the spacer channel pulley bar. (fig. E)
□ Once the strap has been placed over the pulley reinstall the pulley to its original
position, insert the pin and refasten the cotter pin. (fig. F)
□ Place strap from motor side (fig. C) through stopper plate and attach height
adjustment bracket using the supplied cotter pin (fig. B).
□ Repeat step for pulley side without the stopper plate (fig. A).
□ Plug in the motor hoist (B) to the nearest 110 volt power outlet.
□ Use the hand control switch and safely lower the straps until approximately 9 feet of
cable is hanging down.
A
B
E
12
HEIGHT
ADJUSTMENT
BRACKET
Pin
Hook
THE STRAP THAT GOES ACROSS TO THE
SPACER BAR NEEDS TO PASS THROUGH THE
CUT OUT SECTION OF THE MOUNTING PLATE.
Strap hole
Stopper plate
Spring
Cotter pin
C
D
F