Timer Settings; Electrical Diagram; Service And Maintenance - Kongskilde KPC 80 Manuel

Timer settings:

The Function mode switch must
basically be set to R.
On the Time switch, the time interval
of the cutter's movement is set.
On the Range switch, the time inter-
val on the Time switch is set.
In this case, the time interval is 60 sec
x 5,5 = 330 sec.
See also the data sheet of the timer.
4

Electrical diagram:

Service and maintenance:

For your safety, read the safety instructions before
you work on the device.
Maintenance
In general there is no frequently maintenance, such as
greasing and oiling.
Cleaning
Cleaning of the cutting devices is needed from time to
time, depending of the type of material that is running.
Exchanging or turning knifes
1. Release air pressure (A)
Disconnect air pipe (B)
Disconnect power plug (C)
C
B
A