Electrical Installation - Kongskilde KPC 80 Manuel

Inlet, outlet or other guards must not
be opened or removed while the cutter
is in operation.
Mounting:
The cutter must always be installed with minimum 850
mm straight pipe on each side of the cutter, so nobody
can reach the cutting device with a hand. Use the en-
closed clear acrylic 1 meter pipe on the exit side. The
operator can then physically se that the cutter is work-
ing correctly.
When placing the cutting device, make sure that the air
flow direction is correct. See the arrow on the cutter´s
enclosure.
The cutter can be fixed by using 2 pcs. pipe support,
one on each side of the cutter.
The cutting device can be fixed to any stabile layer,
hanging or standing, in any angle, from horizontal to
vertical.
Always use bolt clamps and not quick release clamps
for connecting the cutter with the pipe system.

Electrical installation:

Pin 1 - Solenoid signal
Pin 2 - 24VDC solenoid
GND - Timer box green-yellow connector
Connection:
The power can be taken from the machine, so the cut-
ter is in operation only when the machine is running.
Con A1 24VDC+ (machine run signal)
Con A2 24VDC-
Con 15 24VDC+
Con 18 PIN 1 in connector plug for cutter
3