Salutron Smart Health Manuel De L'utilisateur page 3

To Turn Your Watch On:
1. Remove the LCD display sticker on the watch
face.
2. Hold any button for 3 seconds until the screen
turns on.
Introduction to Your Smarthealth
Pedometer Heart Rate Watch
Our S-Pulse™ technology measures the electronic signals
that pass through your body as a result of the beating of
your heart. This measurement is obtained by the watch's
two sensors: the top metal plate and back battery door.
The battery door is actually the primary sensor plate that
measures these electronic signals off your arm.
The ECG (electrocardiogram) measurement is done when
you place your fingers from the opposite hand onto the top
sensor of the watch. This creates a loop across your body
the watch can now read.
The digital pedometer is powered by a motion-sensing
accelerometer, considered the most accurate and reliable
way to track your steps.
1