Maintenance; General Maintenance - Hoover ONEPWR BH57100 Guide De L'utilisateur

General Maintenance

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and can be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
This product contains no serviceable parts.
If appliance is not working as it should, has been dropped,
damaged, left outdoors or dropped in water, contact cus-
tomer service at 800-406-2005.
WARNING!
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact with
plastic parts. Chemicals can damage, weaken or destroy
plastic which could result in serious personal injury.
Removing Waste from the Collection Container
The collection container should be checked, emptied, and
cleaned periodically to obtain maximum efficiency.
Dry Waste
See Figure 9, page 10
• Remove the battery pack.
• Unlock the locking latches and remove the lid.
• Remove the dry use filter.
• Inspect filter, lightly shake any dust or dirt from the
filter, or replace as necessary.
• Empty the collection container; wash out if necessary.
• Reinstall dry use filter.
• Before replacing the lid, make sure all pieces are
completely dry.
• Replace lid and lock securely.
Liquid Waste
See Figure 10, page 10
• Remove the battery pack.
• Unlock the locking latches and remove the lid.
• Empty the collection container; wash out if necessary.
• Before replacing the lid, make sure all pieces are com-
pletely dry.
• Replace lid and lock securely.
PG.7

MAINTENANCE

Do not allow liquid pick up to remain in the collection
container for extended periods of time. Moisture can
develop in the motor compartment and shorten the life
of the motor.
Do not turn unit upside down, as liquid may enter the
motor unit.
Cleaning/Replacing the Dry Use Filter
See Figure 11, page 11
• Remove the battery pack.
• Unlock the two locking latches and remove the lid.
To Clean/Replace:
• Remove the dry use filter by rotating the filter
counterclockwise to unlock and pull the filter free of the
filter housing.
• Lightly shake any dust or dirt off the filter or replace
as needed.
• Reinstall
locking tab on the filter with the slot on the filter housing
onthe underside of the lid. Rotate the filter clockwise to
lock into place.
NOTE: Make sure the filter is seated properly for dry
vacuuming. Remove the filter for wet vacuuming.
Storage
• Clean all foreign material from the wet/dry vac.
• Clean the outside of the collection container with warm wa-
ter and mild soap.
• Empty and clean the collection container, flexible hose,
nozzles, and attachments with warm water and mild soap
and allow to completely dry before storage.
• Store flexible hose and attachments inside the collection
container or on the lid.
• The collection container should be disinfected as needed
and before prolonged storage.
• Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents such as garden chemicals
and de-icing salts.
WARNING!
WARNING!
the filter by aligning the raised