Heating Operation; Setting The Temperature; Overheating Protection - Powerfix Profi PHG 3000 C3 Mode D'emploi

Heating operation

♦ Ensure that the operating switch
♦ If the appliance is being taken into service for the fi rst time or if you want
to reset the desired temperature, turn the temperature control
MAX position.
♦ Set the operating switch

Setting the temperature

♦ Turn the temperature regulator
♦ When the room has reached the desired temperature, slowly turn the
temperature regulator
This means that the heating element is now switched off .
♦ The heating element is now switched on and off automatically by the
thermostat and the temperature is kept constant.
NOTICE
► The ventilator continues to run when the temperature regulator has switched
the heating element off . The appliance thus circulates the air in the room
and so determines optimally, if the room. has cooled

Overheating protection

The appliance is fi tted with a temperature regulator controlled overheating protector.
Should the appliance become too hot internally, the heating element switches
itself off automatically. However, the fan continues to run, so that a rapid cooling
can be achieved. Once the appliance has cooled itself down, the heating ele-
ment switches back on automatically.
WARNING
As a general rule, overheating has a reason! It can mean a risk
of fi re!
► Check that the appliance can suffi ciently disburse the heat generated:
Is the appliance covered or is it too close to a wall or other obstacle?
Are the grilles on the front or back clear? Is the ventilator blocked?
► If possible, eliminate the problem or contact the Service Hotline
(see Chapter Service).
► Even if you cannot fi nd a cause, but the overheating protection triggers
a second time, you must return the appliance to Customer Services for
inspection or repair.
PHG 3000 C3
is at position 0 (off ).
2
to the desired operating mode.
2
3 fi rstly to the Max position.
3 anti-clockwise until a slight click sound is heard.
3 to the
GB
37