Switching On The Appliance; Pressure Gauge - Reliable MAVEN 100IS Guide D'utilisation

HOW TO USE YOUR IRONING STATION
FILLING THE BOILER BEFORE USE
WARNING: Do not unscrew the cap of the boiler without ensuring that the
appliance is disconnected from the power supply (Fig. 2) and that there is no
pressure inside.
Rotate the boiler cap (B) counter-clockwise. Using the funnel (J), pour water into
the boiler until completely filled (Fig. 3). Screw the cap shut (B).
The product functions with normal tap water.

SWITCHING ON THE APPLIANCE

Connect the appliance to the power supply, ensuring that the voltage indicated on
the identification plate corresponds to your local power supply. When first used,
the iron may give out a little smoke. This transitory effect is perfectly normal and
will disappear very soon. Keep the iron on its grille rest. Press the boiler-starting
switch (L) and turn the steam adjustment knob (K) to the desired setting. Then
press the switch (O) to turn on the iron. Now select the required temperature
using the thermostat knob (F). Wait until the light (M) is on before using the
steam. Before applying a jet of steam to the article to be ironed, release two or
three good jets of steam towards the floor to stabilize the steam flow (Fig. 5).
WARNING: Do not release steam when the iron is standing on its grille rest (I).
STEAM ADJUSTMENT
The appliance is equipped with a regulator (K) that allows the steam output
to be adjusted from a minimum to a maximum setting according to ironing
requirements.

PRESSURE GAUGE

The product has a pressure gauge (N) that indicates the steam pressure inside the
boiler.
If the hand points to the symbol (0) during use, this means that the water in the
boiler has almost depleted: fill it up following the instructions provided in the
"Filling the tank during use" section.
SHOT OF STEAM
Turn the steam adjustment knob (K) to MAX. Set the ironing temperature by
turning the adjustment knob (F) past the symbol (•••). Wait for the indicator lamp
(C) of the iron to turn off. Wait for the steam ready light (M) to turn on. When you
press the steam button (D) for 3 to 5 seconds, a concentrated jet of steam will be
07