Configuration - Keysight Technologies U1177A Manuel D'utilisation

Turn On the U1177A
Set the slide switch to On.
Reset the U1177A
Open the battery cover.
Then, set the slide switch to Setup.

Configuration

The table below shows you the default configurations for the U1177A.
Parameters
PIN code
Baud rate
Data bit
Parity
The COM port configurations for the U1177A, the handheld multimeter, and
the PC/smartphone/tablet must be matched before communication can be
established. All U1177A units and handheld multimeters are shipped with the
same default COM port configurations as shown above.
Maintenance
If any part of the adapter is worn out or damaged, replace it with a new U1177A adapter.
Default Configurations
1234
9600
8
None
Configure the U1177A
Set the slide switch to Setup.
Use a flat-blade screwdriver to push the button-
located in the hole for around three seconds.
Parameters
Stop bit
Deep sleep timer 900 seconds
Mode
6
Default Configurations
1
Discoverable