Prorack 1034413 Mode D'emploi page 5

Install wheel straps
(if not installed earlier)
Slide the open wheel straps
onto the wheel tray with the
red buttons towards you.
Load and Secure your bike — (bike weight limit is 30 lbs.)
Set your bicycle in
the wheel tray with
the hoop lying flat
between the wheels.
In the open position, jaws should clear the bike frame.
The bike carrier can mount above or below most attachments,
such as waterbottles.
Some attachments on the down tube must be removed
if the jaws cannot attach above or below them.
Pull the strap through
wheel spokes on the
front and rear wheels.
Do not let the strap push
against the valve stem.
UNLOADING BICYCLE:
Release the strap
by pushing the
grey button.
1034413B-5/19
NOTE:
The front
wheel of the
bicycle must
rest inside
the hoop.
To avoid paint wear,
clean contact points
on frame before
tightening Jaws.
Close the straps
• Insert the strap
end behind the
red tab.
• Tighten the strap
by repeatedly
lifting the grey tab.
Do not overtighten
the strap!
Unscrew grey
knob and roll
bicyle out of hoop.
Install tray end caps
Raise hoop
and roll bicycle
forward as
jaws meet the
down tube.
BEFORE DRIVING AWAY
• Check the knob.
• Check both wheel straps.
• TIGHTEN IF NECESSARY.
Do not
overtighten!
Tighten grey knob
Do not overtighten!
• If the wheel is still
loose in the tray slide
the strap in the tray
until it rests against
the rim.
• Tighten again.