Prorack 1034413 Mode D'emploi page 4

Attach wheel tray to hoop assembly.
• Insert baseplate bolt head 8"
into slot in wheel tray.
• Use the washers and wing
nut to attach the hoop
baseplate onto this bolt.
• Slide the wheel tray bolt into
the track at the other end of
the wheel tray.
8"
(20 cm)
Combine tray/hoop assembly with universal attachment hardware.
long carriage bolt
(baseplate)
spacer
backbone
nut
upper pad
Spacer positioning—
If your roof rack bars are angled, and the spacer is not
flat against the baseplate, loosen the carriage bolt and
rotate the spacer as needed. You will need to remove the
pad. Be sure to replace it once the bolt is tightened.
1034413B-4/19
Remove the upper pads before continuing.
• Insert a long carriage bolt through the bike
carrier's baseplate.
• Add the spacer between the baseplate and
backbone, and secure with nut.
• Tighten with supplied wrench.
• Reattach the upper pad.
REAR WHEEL TRAY requires the short carriage bolt.
ON SOME SMALLER BIKES—
If the wheel straps need to be between
the roof rack bars, slide them onto the
wheel tray now.
STANDARD BIKES:
Install wheel straps outside the
roof rack bars after step 16.
SMALLER BIKES ONLY:
Slide the open wheel straps onto the wheel
tray with the red buttons towards you.
baseplate
spacer