Festo MTR-DCI Serie Mode D'emploi page 20

3 Instructions on fitting and installation
Warning
Before carrying out fitting, installation and mainten
ance work always switch off the power supply for the
electronic components.
Warning
If an axis is fitted in a sloping or vertical position, the
work load may fall down.
S Check whether external safety measures are necess
ary (e.g. toothed latches or moveable bolts).
S Use the motor unit preferably with self−locking
spindle drives.
You can then avoid the working mass sliding down if
there is a sudden power failure.
The tolerance for the supply voltage must be observed
directly at the operating voltage connection of the
MTR−DCI.
Title
Power supply
Rated current (motor)
Peak current
20
MTR−DCI−42
24 V DC ± 10 %
2 A ± 20 %
3.8 A
Festo P.BE−K−MTR−DCI 0411NH English
MTR−DCI−52
24 V DC ± 10 %
5.1 A ± 20 %
7 A