Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PARALLEL GUIDE
1
Attach the parallel guide
8
as shown
and set the desired parallel distance.
If the tool is not in use the parallel guide
can be used as a blade guard.
REBATING
1
Attach the rebating depth guide
shown and set the desired rebating
distance from 0 - 15.5 mm.
DEPTH ADJUSTMENT
1
To set the desired planing depth from
0 - 3 mm, rotate the depth adjustment
knob 6.
Each click adds / decreases 0.2 mm.
BLADE REPLACEMENT
1
Use a 8 mm wrench to loosen the three
screws.
Caution! Make sure the tool is
switched off and unplugged.
3
Replace the blade or the complete
blade assembly and slide it back into
the tool so that it runs freely.
Caution! Make sure the blade is
placed in the correct position.
122
EN
BEVELING
2
The three V-grooves in the front of the
base plate allow quick beverling. Place
the V-groove of the desired size on the
edge and guide it along.
4
as
2
Set the disired distance on the parallel
guide 8
in order to make rabbets. Plane
as often as necessary to achieve the
desired rabbet.
2
The current depth adjustment can be
read at the indicator on the depth ad-
justment knob 6.
2
Open the blade cover
3
and slide out
the blade assembly.
Caution! The blade is sharp.
4
Adjust the height of the blade assembly
with the hex key and securely tighten
the three screws loosened in step 1.
There are two blades on the spindle!
Caution! Always use identical
blades and blade assemblies.
1
1
1
1
1. 1.
2. 2.
3. 3.
3
2
2
2
2
4
1.
1.
2. 2.
EN
123
Publicité
Table des Matières
