After Installation - LUCCI FUTURA Serie Guide D'installation

REVERSING SWITCH
Your ceiling can operate either summer or winter mode.
SUMMER Mode: The reverse switch shall be in the "down" (SUMMER) position to
make the fan rotate in an anticlockwise direction. The airflow will be directed downwards, for cooling
in summer. WINTER Mode: The reverse switch shall be in the "up" (WINTER) position to make the fan
rotate in a clockwise direction. The airflow will be directed upwards assisting in the circulation of
warm air, for energy conservation in winter.
Reverse Switch
WOBBLE:
NOTE: CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY
ARE MOUNTED ON A RUBBER GROMMET. IF THE FAN WAS MOUNTED RIGIDLY
TO THE CEILING IT WOULD CAUSE EXCESSIVE VIBRATION. MOVEMENT OF A FEW
CENTIMETRES IS QUITE ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE
FIX THE MOUNTING BRACKET AND DOWN ROD ARE SECURE.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please
refer to the instruction on how to use the balancing kit. The balancing kit can be
used to assist
re-balancing should the ceiling fan become un-balanced again. Store your balancing kit away after
installation for future use if required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations
and frequency signals superimposed in the electricity for off-peak hot water control, may
cause a change in fan motor noise. This is normal. Please allow a 24-hour "breaking -in" period,
most noises
Fig. 14

AFTER INSTALLATION

FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH