Publicité
ASSEMBLY INSTRUCTIONS
5.
Pour the Fire Glass around the burner.
6.
When the Fire Pit is not in use and has cooled completely, cover with
the Vinyl Fire Pit Cover.
Never place the cover on a HOT Fire Pit. Fire Pit
must be cooled completely before covering.
7.
Connect hose and regulator to cylinder. The propane gas and cylinder
are sold separately. Use a standard 20 lb. propane cylinder only. Use
this fire pit only with a vapor withdrawal supply system. See Chapter 5
of the standard for storage and handling of liquefied petroleum gas,
ANSI/NFPA 58. Your local library or fire department should have this
book. Storage of an appliance indoors is permissible only if the cylinder
is disconnected and removed from the appliance. A cylinder must be
stored outdoors in a well-ventilated area out of reach of children. A
disconnected cylinder must have all dust caps tightly installed and
must not be stored in a building, garage or any other enclosed area.
The maximum inlet gas supply pressure: 250 psi. The minimum inlet
gas supply pressure: 5 psi. The minimum hourly rate of 1,0000 Btu is
required input rating for a fire pit for automatic operation at rating less
than full input rating. The pressure regulator and hose supplied with
the appliance must be used. The installation must confirm with local
codes or in the absence of local codes, with national fuel gas code,
ANSI Z223.1/NFPA54, natural gas and propane Installation Code, CSA
8149.1, or propane storage and handling code, 8149.2.
8
Standard 20 lb. Tank
Publicité
