Publicité
OPERATION INSTRUCTIONS
CARE AND MAINTENANCE
Do not touch or move fire pit for at least 45 minutes after use. Fire pit is hot to the touch. Allow fire pit to cool before
To enjoy years of outstanding performance from your fire pit, make sure you perform the following maintenance activities on
a regular basis:
Keep exterior surfaces clean.
1.
Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2.
While cleaning your unit, be sure to keep the area around the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use it. It must be replaced.
a. Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
b. Do not obstruct the flow of combustion and ventilation air.
c. Keep the ventilation opening of the cylinder enclosure free and clear from debris.
3.
Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of possible blockage
include:
• Gas odor with extreme yellow tipping of flame.
• Fire pit does NOT reach the desired temperature.
• Fire pit glow is excessively uneven.
• Fire pit makes popping noises.
• Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire pit and render it unsafe for
use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
• Carbon deposits may create a fire hazard. Clean burner with warm soapy water if any carbon deposits develop.
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
STORAGE
•
Between uses:
•
Turn Control Knob OFF.
•
Disconnect LP source.
•
Store fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and
debris).
•
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
Wait until fire pit is cool before covering.
DURING PERIODS OF EXTENDED INACTIVITY OR WHEN TRANSPORTING:
•
Turn the control knob off.
•
Disconnect LP source and move to a secure, well-ventilated location outdoors.
•
Store fire pit in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and
debris).
•
If desired, cover fire pit to protect exterior surfaces and to help prevent build-up in air passages.
•
Never leave LP cylinder exposed to direct sunlight or excessive heat.
Wait until fire pit is cool before covering.
FOR YOUR SAFETY
touching.
12
Publicité
