O Perating Conditions; P Rotective Devises; R Otation Of Gearbox Head; G Rinding Belts - SUHNER ABRASIVE UTG 9-R Dossier Technique

Wraparound angle
Max. pipe diameter
Sound pressure level EN 60745
Noise emission level
Vibration EN 60745
Weight w/o cord set
Protection class
The specified vibration value was measured with a
standardised test procedure. It can be used to
compare products or to make an initial assess-
ment of the exposure. The vibration emissions may differ
from the specified value, depending on how the power
tool is used. Operating personnel must be protected with
defined safety measures based on the estimated expo-
sure under the actual conditions of use (these must take
into account all phases of the operating cycle, e.g. the
times when the power tool is switched OFF and the times
it is switched ON, but is not under load).
2.4 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95 % at +10°C not condensed
3.
haNDLINg
3.1 p
rotectiVe deVises
3.1.1 p
rotection of the mAchine
s
tArting current limitAtion
The electronically controlled soft starting provides for
smooth starting of the machine. Due to the low machine
starting current a 16 A fuse is adequate.
t -
emperAture dependent oVerloAd protection
For protection against overheating, when a critical tem-
perature is reached the electronic safety feature switches
into the cool-down mode.
Then the machine continues to run at approx. 1,300 rpm
and the electronic constant speed control is deactivated.
After a cool-down time of approx. 10 - 20 sec. the ma-
chine is again ready for operation.
Turn the machine off and back on again to activate the
electronic constant speed control.
When the machine is at operating temperature the tem-
perature-dependent overload protection reacts at a cor-
respondingly earlier time.
o /
VerVoltAge restArting protection
On short-time outage of the power voltage (pulled power
connector, unstable power voltage etc.) the machine will
stop. On recovery of the power voltage the machine has
to be turned off and back on again. The machine is then
max. 180° ready for operation.
45mm
3.2 r
81dB, K=3dB
92dB, K=3dB
2 2
4.0m/s , K=1.5m/s
3.0kg
II accessible position for special work operations.
Remove the four screws and carefully rotate the gearbox
head into the desired position, making sure that it does
not lift off the motor housing by more than 1 mm. Screw in
the screws and tighten down.
3.3 g
/ o
PERaTIoN
speed!
Install clean grinding belts only.
3.3.1 f
Before replacing the grinding belt, remove the pressure
on the swivel arm.
hindrance. Do a test run for at least thirty seconds without
load. Do not use damaged, eccentric, or vibrating grind-
ing belts.
3.4 w
The optimal grinding results are obtained when the grind-
ing belt is steadily moved back and forth under slight
pressure.
otAtion of geArBox heAd
The gearbox head can be rotated relative to the
stator housing in steps of 90° which enables the
ON/OFF switch to be brought into a more easily
rinding Belts
Use grinding belts only whose
max permitted speed is equal to or
higher than the machine's idle belt
itting the nonwoVen And grinding Belts
Trial run!
Check the grinding belt before use. The grinding
belt must be installed properly and run without
orKing instructions
23