Crimestopper Security Products BSD-200 Mode D'emploi page 15

6. Mount the sensor using the provided screws to the mounting angle
adaptor.
7. Using 1 of the supplied alcohol pads, clean the surface of the adap-
tor that will be mounted to the vehicle.
8. Peel and stick 1 side of the pre-cut adhesive tape and apply it to the
mount.
9. Using a second alcohol pad, clean the area on the bumper where the
sensor will be mounted. If the bumper has snow, mud or heavy dirt,
clean the area prior to using the alcohol pad.
10. Once the bumper is prepped, install the sensor onto the bumper.
Ensure that the sensor is mounted so that when on the vehicle it will
be aimed properly and not up or down.
NOTE: If you are installing the BSD-200 in a cold climate, we recom-
mend that the bumper where the sensors will be mount should be at
room temperature to help insure that the adhesive sticks properly.
All manuals and user guides at all-guides.com
sensor mounting
15