Paradise GL33200 Guide Rapide page 4

6. Transformer interface, controls and modes installation types
ENTER Press to confirm a selection.
Press to modify or change a mode. Press it to exit any
MODE
settings without saving.
/
Press these to select and go through the interface.
+
Press at the same time to change time and date. *Neces-
MODE ENTER
sary for Timer, Auto and Sunwise settings to work properly.
+
Press at the same time to change Sunwise time zone.
MODE
*Necessary for optimal Sunwise mode.
The time at which the lights will turn On. This step comes
START
after selecting a Mode. (Shows up for Timer Mode only)
The time at which the lights will turn Off. This step comes
END
after selecting a Mode. (Auto, Timer and Sunwise only)
Select this to close the lights at dawn. When selecting an
end time, scroll using up and down until the icon shows up
(Auto and Sunwise only)
NORTH zone
NORTH
Refers to locations from north of Chicago, IL.
CENTRAL zone
CENTRAL
Refers to locations between Chicago, IL and southern
Missouri.
SOUTH zone
SOUTH
Refers to locations south of Missouri.
LOAD
0%: Normal Less than 20%: Normal
Modes
ON
OFF
TIMER
AUTO
SUNWISE
*The channels will only turn on at the exact start time selected for Timer and dusk for Sunwise.
LOAD
Less than 100%: Normal
Recommended Control Settings
Functionality
Always ON
Always OFF
Fixed start and end time
Uses the light sensor
(photocell) to Open/Close
the lights
Astronomical timer auto-
matically adjusts to local
sunrise/sunset times
Mode
LOAD LOAD
Blinking:
Overloaded over 100%
Outdoor
YES
YES
YES
YES
YES
Zone Location (Sunwise)
Enter Up Down
Photocell
LOAD
Over 120%, shuts down
reduce load
Indoor Dusk-to-Dawn
YES
YES
YES
NO
YES
Load Icon
START Timer
END Timer
DAWN Icon
Lighting Modes
North
Central
South
NO
NO
NO
YES
YES