Cequent Performance Products 76076 Instructions D'installation page 4

Remove screws using T25 Torx bit – Remove (4) screws exposed at wheel well liner. Pull
back wheel liner to expose an additional (1) screw for removal.
Gently pry/pull off the body trim piece at the upper wheel well to expose (2) screws to
be removed, using T25 Torx bit. Note: Plastic body panel removal tools suggested to
ease removal.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Remove (2) screws from the bottom of each wheel well liner. Remove (4) screws from
the middle underside area of the fascia. Do the same on both sides of vehicle.
Gently pull off vehicle bumper fascia. Note: Plastic body panel removal tools suggested
to ease removal. You will need to disconnect/unplug all electric connectors from sensors
and lights attached to the bumper fascia and unclip the wiring from the bumper fascia to
remove it from the vehicle. Set the bumper fascia aside.
Sheet 4 of 18 76076NPP 6-15-16 Rev. A