Publicité
Les langues disponibles
Les langues disponibles
Hitch Shown In Proper Position
Equipment Required: Fishwire (provided)
Fastener Kit: 41549GF
Wrenches: ¾"
Drill Bits: 7/16"
Fasteners typical
Both sides
Make sure blocks do not
Overlap inside frame before
Tightening.
1 1 1 1
Qty. (6)
Carriage Bolt ½-13
2 2 2 2
Qty. (6)
Block ¼ X 3"
On vehicles with vibration dampener assembly mounted to driver's side frame rail, remove and retain dampener and
fasteners for re-installation after hitch installation. See Figure 2 for dampener re-installation.
NOTE: Vibration dampener cannot be re-installed on Flareside models.
NOTE: Lowering spare tire may ease installation
1.
Raise hitch into position, aligning holes in hitch side brackets with holes in vehicle frame as shown.
2.
Install ¼ X 3 block and carriage bolt thru end of frame into rearmost slot in frame, each side. Fasten with lock washers and nuts.
Finger-tighten only at this time.
3.
Fishwire ¼ X 3 blocks and carriage bolts, 2 each side, thru forwardmost square hole in side of frame rail and into holes aligned
with holes in hitch side bracket. Fasten with lock washers and nuts.
NOTE: Make sure blocks do not overlap inside frame before tightening.
NOTE: On vehicles with Vibration Dampener assembly, see Figure 2 to install dampener before tightening fasteners.
4.
Raise spare tire back into position.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2011 Cequent Performance Products
Installation Instructions
Ford F-150
Lincoln Mark LT
Wiring Access Location: PU3
Figure 1
3 3 3 3
4 4 4 4
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft.
Sheet 1 of 6
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Trailer WT (LB)
Weight Distributing
Weight Carrying
Ball Mount
Shackle bracket
Typical both sides
Qty. (6)
Lock Washer ½"
Qty. (6)
Hex Nut ½-13
41549GN
Part Numbers:
78271
Max Gross
Max Tongue
WT (LB)
10,000
1000
6000
600
9-22-11
Rev. A
Form: F205 Rev A 5-6-05
Publicité
Table des Matières
Manuels Connexes pour Cequent Performance Products 78271
Sommaire des Matières pour Cequent Performance Products 78271
- Page 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 6 41549GN 9-22-11 Rev. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05...
-
Page 2: Installation Instructions
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 2 of 6 41549GN 9-22-11 Rev. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05... -
Page 3: Numéros De Pièce
Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 3 de 6 41549GN 9-22-11 Rév. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05... - Page 4 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 4 de 6 41549GN 9-22-11 Rév. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05...
-
Page 5: Números De Partes
Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684. Hoja 5 de 6 41549GN 9-22-11 Rev. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05... - Page 6 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York. V.E.S.C. Regulación V-5 y SAE J684. Hoja 6 de 6 41549GN 9-22-11 Rev. A 2011 Cequent Performance Products Form: F205 Rev A 5-6-05...