Installation - Caloric CVI28-SS Guide D'installation Et D'utilisation

Location Requirements (Continued)
WARNING:
PLEASE MAKE SURE NOT TO DAMAGE ELECTRICAL WIRING OR OTHER NON-
APPARENT EQUIPMENT WHEN CUTTING. WHEN CONSTRUCTING THE CARPENTRY,
ALWAYS FOLLOW ALL APPLICABLE BUILDING CODES AND STANDARDS.
WARNING: AT LEAST TWO (2) PERSONS ARE NECESSARY TO LIFT AND POSITION THE
HOOD.
WARNING: BE CAREFUL WHEN INSTALLING THE HOOD AS IT MAY HAVE SHARP EDGES.
WE RECOMMEND THAT YOU WEAR PROTECTIVE GLOVES.
LOCATION PREPARATION
• It is recommended that the exhaust system be set up before the hood is installed.
• Before cutting, make sure that the separation distances for the fittings in the walls and/
or roof are adequate.
• Before mounting the cabinet to the wall, cut the opening in the bottom of the cabinet.
1. Disconnect the power source.
2. Determine the method of discharge to be used: discharge through the wall or roof.
3. Choose a flat surface for the hood assembly. Place the protective material on this
surface.
4. Using two or more people, lift the hood over the covered surface.

Installation

PREPARING THE CUT-OUT
1. Use a jigsaw or reciprocal saw to cut an opening in the bottom of the cabinet, inside
the frame.
NOTE: For frameless cupboards, a ¾" (1.9 cm) front and rear edge is required to form a
frame in the bottom of the cabinet. A ¾" (1.9 cm) thick support rod (not included) may be
required for certain types of cabinets.
Pg 12