Stick Calibration; Power Off - Absima CR4S Mode D'emploi

4.4 Stick Calibration

This function is used to set the neutral position for throttle and wheel.
Ever y transmitter is calibrated before leaving the factor y, however if recalibration is required,
please follow these steps:
1 . Tu r n a n d h o l d t h e w he e l as fa r c lo c k w i s e as i t w i l l tur n, h o l d t he t h rottl e a l l t he wa y for wa rd,
th e n t u r n on t h e t ra ns m itte r i n cal ib rati on mo d e .
• The R.LED and G.LED will flash twice.
2 . Ca l i b rate wh e e l: Tur n t h e w he e l co m p l ete l y c l o c k w i s e, t he n co m p l ete l y co unte rc l o c k w i s e .
• When calibration is completed the R.LED will be off.
3 . Tr i gge r ca l i b rat io n : Pu ll th e t r igge r bac k t he n for ward a s fa r a s i t w i l l go.
• When calibration is completed the G.LED will be off.
4. O nce ca l i b rat i o n is co m p l ete p res s th e b i n d ke y to s a v e a n d ex i t .

4.5 Power Off

Follow the steps below to turn off the system:
1. Disconnect the receiver power.
2. Toggle the transmitter's power switch to the off position.
Make sure to disconnect the receiver power before turning off the transmitter.
•
Danger
Failure to do so may lead to damage or serious injury.
www.modellmarkt24.ch