Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
{LEVEL}
Permits the adjustment of the level of channel 1 or 2
separately or simultaneously.
Signal gain can be set from –96 to
LEVEL
+31.5 dB. The default value is 0 dB.
{CONFIGURE ALARM}
It is possible to associate the STATUS Led colour and/or a
GPI relay activation to each detected error.
Alarm relay activation depends of the ENABLE selection of
the controller board menu GPI REPORT.
Associates to each error the STATUS
ALARM LEVEL
led colour: GREEN, YELLOW, RED
and FLASH RED. This selection has
no influence on the {STATUS} menu
display.
The default value NONE is assigned
ALARM REPORT
to errors. Alarm relay activation will
be associated to an error when GPI is
set.
Status and Report
This table shows the front Led colour and the report action according to the level of a given error condition. Notice that the
"Flashing Yellow" indicates that the SELECT button on the front panel has been pushed, and the card is being accessed via
the communication protocol.
Overload on Input 1
Overload on Input 2
No signal detected on Input 1
No signal detected on Input 2
Card accessed via the communication protocol
Rear Panel not matching
: Factory default.
Note: The non requested message affectation to an alarm status can only be accessed by the communication protocol (serial
port)
{FACTORY DEFAUT}
RESTORE
Non
GPI
requested
Report
-
-
-
-
Guide to Installation and Operation
Set the module with the factory default
parameters.
Green
Yellow
Red
-
-
-
-
ADA-1031
Flashing
Flashing
Red
Yellow.
-
-
-
-
-
-
Yes
-
Yes
-
Publicité
Table des Matières
