Installation Instructions - Igloo FRW216 Notice D'utilisation

V Installation Instructions
Beforeusingyourthermoelectriccellar:
Remove the exterior and interiorpacking
-Check to be sure the following parts are included:
5 WoodenShelves
-Beforeconnecting the appliance to the power source, let it stand upright for approximately 2 hours.
This willreduce the possibility of a malfunction in the cooling system from handling during
transportation.
-Clean the interior surface withlukewarm water usinga soft cloth.
-Place yourappliance on a floorthatisstrongenough to support the appliancewhenitisfullyloaded. To
levelyourappliance, adjust the front legs at the bottom of the appliance.
-For recedes installation awayfrom direct sunlight and sources of heat (stove, heater, radiator,
etc.).Direct sunlight
mayincreaseelectricalconsumption. Extreme cold or hot ambienttemperaturesmayalso cause the
appliances not to performproperly.
-Not designed for placement in adage or basement.
-The applianceis for indoor use only.
Caution: Pleasekeep the applianceawayfrom substance, whichcan cause ignition.
INSTALLING HANDLE
This winechillerincludesastainlesssteelhandlethatis not required to operatethis unit. To install the
handlepleasefollow the below instructions:
1. Pull away the doorgasket in the area where the handleis to beinstalled on the leftside as
shownbelow in Illustration # 1. The gasketiseasilydisplaced by hand, no tools are
necessary.
2. Align the handlewith the screwsalreadyinstalled in the door frame for yourconvenience.
Tighten the screwsusing a Phillips headscrewdriveruntil the handle sets both flush and
securedtightlyagainst the door frame. (DO NOT overtighten as thiswill cause damage to the
handleassembly).
3. Replace the doorgasket to its original position.
may affect the acryliccoating and heat sources