DAY Useful Everyday 721995 Mode D'emploi page 50

Inserting/removing the hose
• Insert the suction hose connector into the suction opening on device (see arrow). It must
audibly lock into place.
• To remove the suction hose push the knob on the connector and pull the suction hose
out.
Inserting/removing the telescoping tube
• Insert the open end of the handle into the corresponding opening on the telescoping
tube. In the process, turn the handle back and forth somewhat. Check to make sure that
the connection is secure.
• To remove the telescoping tube pull it off of the handle.
Adjusting the length of the telescoping tube
• Push the slider on the telescoping tube down and set the desired length.
• Release the slider and move the tube forward until it locks into place.
Mounting/removing suction nozzles
• Insert the open end of the telescoping tube in one of the enclosed suction nozzles up to
the stop. Turn the nozzle back and forth slightly in the process.
• The suction nozzles can also be attached directly to the suction hose without the
telescoping tube for more � exibility.
• To remove a suction nozzle pull it off .
Inserting the dust bin
• Take the dust bin by the handle and � rst
place the bottom of the bin in the device
(the bottom is facing down and handle is
facing up). Then push the handle against
the device housing until the dust bin
audibly locks into place. Hold the device by
the handle and lift it to check whether the
dust bin is properly seated.
50