1. Using masking tape or repositionable tape strips supplied, dry-fit
an adhesive pedestal at the centre of the hood. To find the center of
the leading edge of the hood, use a tape measure to measure to
opposite corners of the hood (or some other body line or feature) and
adjust the pedestal until both measurements are identical.
NOTE: The fingers incorporated on the leading edge of the pedestal
ensure the correct position relative to the hood edge. When correctly
positioned the fingers should contact the leading edge of hood.
À l'aide du ruban adhésif ou des bandes de ruban repositionnable
fournis, dri fit un socle adhésif au centre du capot. Pour trouver le
centre du bord d'attaque du capot, utilisez un ruban à mesurer pour
mesurer les coins opposés (ou arêtes) de la hotte et d'ajuster le
socle jusqu'à ce que les deux mesures sont identiques.
REMARQUE: Les doigts sont intégrés à la fine pointe de la colonne
d'assurer la bonne position par rapport au bord de la hotte. Lorsqu'il
est correctement positionné les doigts doivent contacter la fine
pointe de la hotte.
2. The positions of the remaining pedestals are shown in the
illustration. Use the center mark on the leading edge of the
pedestals for accurate measuring. Use masking tape or the
repositionable tape strips to temporarily attach the pedestals as
shown.
Les positions des socles restants sont représentés dans
l'illustration. Utilisez la marque centrale sur le bord d'attaque des
socles pour une mesure précise. Utilisez du ruban adhésif ou des
bandes de ruban repositionnable pour fixer temporairement les
socles comme indiqué.
3.
Mount the two (2) bumpons in the locations indicated in the
illustration. Note- bumpons must be mounted to the hood
surface. If they are mounted to the hood protector they will
wear through the paint.
Monter les deux (2) bumpons noirs dans les endroits indiqués sur
l'illustration. Attention - bumpons doivent être montées sur la
surface du capot. Si elles sont montées sur le capot de
protection qu'ils porteront à travers la peinture.
HD 8G08 Rev0.Apr20, 2016 2 of 5