Princeton Tec SYNC 150 Notice D'utilisation Et D'entretien

ENGLISH
Battery Installation - See Figure 1
3 AAA • Alkaline (LR03)
• Lithium (L92)
• Rechargeable NiCad or NiMH
Princeton Tec cares about the environment and
recommends recycling batteries. For more in-
formation about battery recycling, please go
www.batteryrecycling.com.
Install three AAA batteries according to the po-
larity markings on the inside of the cabinet. Ob-
serve proper battery polarity when installing the
batteries. Improper installation of the batteries
will damage the light and void the warranty.
Rotate the door to the closed position,
squeeze the body between your forefin-
gers and thumb to snap the door latch over
the catch.
C
WARNING
Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries
immediately.
• Remove batteries during long periods of
storage. NOTE: Rechargeable NiCad or NiMH
batteries may result in reduced brightness due
to lower nominal voltage.
Switch Operation - See Figure 2
Modes are selected by rotating the power dial
to the desired setting. The default "lockout" set-
ting positions the dial indicator so it is protected
from accidental activation during transport. One
step forward activates red Ultrabright mode. The
next step forward is the off position. Next comes
Ultrabright low flood mode. An additional step
activates Ultrabright high flood mode. The next
setting provides the Maxbright spot beam. The
final step activates both spot and flood beams
for maximum output in the Dualbeam pattern.
Power Consumption
Refer to the burn time chart for performance data
for different battery types and mode settings.
The times listed in this chart assume you start
with fresh batteries and use only one mode.
Troubleshooting
If the Sync fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is con-
firmed.
Figure 1 – Battery Replacement
1
Figure 2 – Switch Operation
5 MODES
DUAL BEAM
to
HIGH FLOOD
LOW FLOOD
DISTANCE
(METERS)
Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of
•
0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale
•
Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-
tungsstärke des Vollmonds in einer klaren Nacht.
• Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la source
lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la
luminosité d'une pleine lune dans un ciel nocturne dégagé.
• Check the light for water contamination on the
circuit board. The light will resume normal op-
eration once the water is shaken or blown out
and the light is left open until completely dry. If
the light has been contaminated with salt water,
flush the unit with fresh water and dry as de-
scribed above.
USA– International 5-Year Warranty
WARRANTY – Princeton Tec warrants this prod-
uct to be free from defects in workmanship and
materials under normal use for 5 years. This war-
ranty covers all of the component parts of the
product except batteries. This warranty does not
cover deterioration due to normal wear or damage
due to misuse, alteration, negligence, accidents,
or unauthorized repair. Princeton Tec will repair or
replace parts which are defective in workmanship
or materials.
Your authorized Princeton Tec Dealer and Princ-
eton Tec are the only facilities authorized to repair
the product. After (3) unsuccessful attempts (with-
in the warranty period) to repair the product, you
have the right to elect replacement of the prod-
uct or a refund of the purchase price less allow-
ance for use of the product. NO INCIDENTAL OR
CONSEQUENTIAL DAMAGES ARE INCLUDED IN
THIS WARRANTY. (Some states do not allow the
exclusion or limitation of incidental or consequen-
tial damages, so the above limitations or exclu-
sions may not apply to you.) This warranty gives
you specific legal rights, and you may also have
other rights which vary from state to state.
Remplacement des piles
2
3
Modes de fonctionnement
TOTAL BURNTIME 75 H
SPOT
100 H
150 H
200 H
RED
0
6 24 32
Princeton Tec reserves the right to change
product specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BpA) a
chemical known to the State of California to cause birth
defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these sim-
ple steps:
If your light fails to operate, follow these simple steps:
1) Check batteries. Replace if necessary.
2) To send your light in for repair or replacement,
first contact Princeton Tec customer service on
1-800-257-9080 to request an RMA number.
Please have your light model, date of purchase
and a brief description of the fault you are
experiencing. No warranty repairs will be
accepted without an RMA number.
3) Return the light without batteries to:
Princeton Tec, PO Box 8057
08650. Postage due and freight collect items will
not be accepted.
4) Upon receipt your light will be processed in
about two weeks. Please allow additional time
for return transportation from NJ.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2018 Princeton Tec
Batteriewechsel
4
Schalterbetätigung
RED
OFF
BEAM DISTANCE
BEAM DISTANCE
58 m 56 m 22 m
100 H
52 m 48 m 26m
32 m 29 m 18 m
24 m 23 m 16 m
6 m 5 m 3 m
0 H 0.5 H 10 H
58
T= Time/ Zeit/ Temps
Time/ Time/ Temps Temps
Trenton NJ