SULION TONES 072645 Mode D'emploi page 11

adequate size for the fan's consumption and technical specifications). Only use the fan's
control to turn it on or stop it.
6. It is recommended to not use these types of fans along with gas installations simulta-
neously in the same room.
7. The fan must be not be moving and must have come to a complete stop before changing
its direction of rotation. This will prevent damage to its motor and to the control unit, when
applicable.
8. Do not insert anything that could hit the fan's blades into its pathway while it is moving,
as this could cause damage to people, can damage the blades, and can offset the balance of the
unit, causing vibrations and wobbling.
9. After installing the fan, ensure that all fastenings are secure and tightened in order to
avoid any noise caused by loose elements.
10. Due to the fan's movement, certain fastenings may become loose. Check all fastenings
twice per year at a minimum in order to ensure that they are sufficiently tight. If necessary,
they must be retightened.
11. If the power cord is damaged, it must be replaced by the manufacturer, its after-sales
service or similar qualified personnel in order to avoid any malfunction.
Note: The important warnings and instructions indicated in this manual are not guaranteed to
cover all possible conditions and situations that may occur. It must be understood that common
sense, precaution, and care are factors that cannot be included in all products. These factors
can and must only be provided by the user who maintains and enjoys this fan.
Device technical spectifications
Tensión y frecuencia nominal
Ampoule
Type of bulb
Classe de protection
Degré de protection
Température de travail
Régulable/Non-régulable
Inclinaison maximale du plafond sur lequel il peut être installé
Speed
Fan power (W)
Fan RPM
Fan airflow (m /min)
3
Installing a fan without a shaft, flush with the ceiling, can reduce airflow.
220-240V~AC 50Hz
Máx. 3x40W E14
C37
Clase 1
IP20
-20 ↔ 50ºC
No dimable
17º
1 2 3
17 28 48
110 154 199
41 60 83
EN
11