LEAD dynamic SSW20 Manuel D'utilisation page 5

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
You can attach the LED STRIP products to walls or
ceilings to generate continuous bar lighting.
Note
Note that the protection class refers only to your
LED STRIP product. You must protect the wiring, the
power supply and the WiFi dimmer from moisture.
Danger
Always only operate LED STRIP products in an
unwound state. Operating an LED STRIP product in a
wound state may lead to irreparable damage.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
Note
Please observe the warnings prior to installation.
Note
WiFi control must be accessible for configuration of
your product.
1
Remove dirt, grease and other residue from the sur-
face on which you want to mount your LED STRIP
before installation. Peel the protective film away from
the adhesive strip and position the LED STRIP in the
required place applying light pressure.
Subject to errors and amendments
?
service@lead-energy.com
www.lead-energy.com
Mounting
Information / Technical support: www.lead-energy.com