Aux Function; Usb Function; Fm Radio Function - SoundVision LedTower Li Manuel D'utilisation

LedTowerLi
8. If you manually turn off the Bluetooth in smartphone or the smartphone is
far away from the unit (over 10m), the connection between speaker and
smartphone will lose, the unit will go back to Bluetooth standby mode.
Ensure the Bluetooth in your smartphone at "searching device" mode, keep on
pressing "pairing" on the top panel, and then follow above steps to reconnect it

AUX FUNCTION

1. Short touch the "SV" button on the front panel or "AUX" button on the
remote control to enter the AUX input mode.
2. The AUX mode is automatically activates when a signal is transmitted from
the back panel AUX connector.

USb FUNCTION

1. Short touch the "SV" button on the front panel or "USB/SD" button on the
remote control, to enter into "USB" mode. Connect the USB key, the music
files will be played automatically.
2. Press , ,
status.
3. The USB interface supports charging and playback of compatible
smartphone and tablets. (USB port charging: 5V / 1A)
SD CARD FUNCTION
1. Short touch the "SV" button on the front panel or "USB/SD" button on the
remote control, to enter in SD card reader mode.
2. Insert an SD memory card (not supplied) into the memory card expansion
slot. Make sure it is inserted at the correct way.

Fm RADIO FUNCTION

1. Press the "STANDBY" button to turn the unit on,.
2. Short touch the "SV" button on the front panel or "FM" button on the remote
control to enter into "FM" mode. Ensure the FM antenna has been fully
extended.
3. Press the and
and and hold, the unit will scan the radio station, and stop once found
one.
PROGRAmmING & PlAYING OF Fm RADIO PRESETS
1. Follow the steps for Playing the FM Radio.
2. Press "Scan" button on the remote to search and preset stations in memory,
(for example "P01" – this will blink on the display - and then the preset
station frequency number will show on the display).
. These three buttons can control USB playback
to select the desired FM radio station. Press
11
EN