USE
Warning: The fan can only be used if properly assembled in good condition.
The fan functions are operated with both the keypad of the control panel and the
remote control which must be pointed at the front (maximum distance of about
4m) towards the control panel; for the first use take off the tab transparent
plastic of the batteri's side (type AAA), not included inside the box.
The fan has the following setting and control elements:
Stand-by-ON button "
-
- Ventilation: the three speeds are selected by pressing the "
"SPEED" of the remote control: the symbol corresponding to the selected speed
will light up: (
- Mode: the three modes are selected by pressing the "MODE": button:
1. Normal: constant ventilation
2. Silent: constant and silent ventilation (symbol
3. Natural: intermittent ventilation (symbol "
shown here.
Maximum speed selected
Minimum speed selected
Timer: sets the operating time at which the unit shuts down. Press the "TIMER"
-
button repeatedly: each press changes the time in ½ hour intervals (from ½
hour to 7½ hours), and the selected duration will be shown on the control
panel. To deactivate the timer, press the button until the timer turns off.
Swing (right-left): press the "SWING" button, turn it on and or turn it off to
-
press again
Vertical tilt (high-low): This is selected by tilting the motor body to the desired
-
direction (high-horizontal-low).
Heruntergeladen von
manualslib.de
": to turn the fan on or turn it off in standby mode
= min;
= med;
Handbücher-Suchmachiene
= max).
)
"), as shown in the diagrams
Medium speed selected
15
" button or